A full polishing range.
From cutting and one-step correction to final finishing.
Preparation & Paint Correction
Inspect, wash, decontaminate and prepare the finish before a ceramic coating installation.
Guides in this topic
39 guides
Fisheyes in Refinished Paint: A Detailing Inspection Guide
Small crater-like defects on a repainted panel should be distinguished from mineral deposits and surface contamination. Detailing can reveal the finish clearly, but it cannot establish the original spraying cause by appearance alone.
Cleaner Dwell Time vs Drying Time: Two Different Workshop Decisions
A cleaner’s instructed contact period does not permit it to dry on every surface. Keep dwell time and visible drying under separate control.
Dilution by Volume and Dilution by Weight: Keep the Units Explicit
A dilution instruction should state both the ratio convention and the measurement units. A volume recipe cannot be silently converted to weight.
Residue in Pump Sprayers: Prevent an Unplanned Product Mixture
The last contents of a sprayer can affect the next preparation task. A clear bottle wall does not prove that its pump and hose are free of residue.
Cleaning Residue in Panel Gaps Before Coating
A panel can look ready while gaps retain cleaner or polishing residue. Include accessible joints in the preparation check before coating the adjacent paint.
Masking Tape Adhesive on Prepared Paint: Reset the Local Surface
Removing polishing tape can leave a local preparation question. Inspect the taped boundary before treating the panel as uniformly ready for coating.
Wax Residue in Paint Texture: Avoid Judging Readiness by One Wipe
Older protection can remain unevenly around textured paint, badges and tight areas. A single clean-looking wipe is not a complete preparation assessment.
Clay Lubricant Residue Before Polishing: Complete the Removal Step
Mechanical decontamination adds its own product history to the panel. Remove the lubricant as instructed before assessing the next polishing or coating step.
Adhesive Remover Near Plastic Trim: Map the Runoff Before Treatment
A residue remover may be appropriate for one finish while unsuitable for adjacent materials. Plan where the product can spread before applying it.
Paint Assessment After PPF Removal: Separate Film Residue from Finish Damage
Removing PPF reveals a surface that needs assessment before polishing. Adhesive residue, paint differences and damage must not be grouped into one correction task.
Detachable Vehicle Hardtops: Treat the Storage Surface as Part of the Scope
A detachable hardtop may be coated separately from the vehicle and later stored. Include its surface identity, handling and storage contact in the project discussion.
Roof-Rack Removal Before Coating: Define the Hidden Surface Scope
A roof rack can conceal paint and introduce contact areas that differ from the visible roof. Agree access and responsibility before describing the whole roof as treated.