IN DEVELOPMENT / MATRIX SERIES
MATRIX ELITE P7020
The next flagship of the MATRIX series.
75%Solids content
NANOLAB®SURFACE-SPECIFIC PROTECTION
CHEMISTRY YOU CAN TRUST.50 ml
SURFACE-SPECIFIC PROTECTION
PLASTIC. Ceramic coating for plastic & rubber
Give the details the protection they deserve.
A flexible ceramic coating for interior and exterior plastic and rubber, designed to add water repellency and protection from everyday exposure.
Designed for
Interior and exterior plastic and rubber surfaces
50 mlApplication guidance below
50 mlBottle size
30 minTack-free time
30 daysFull cure
Developed for the surface.
Designed for the process.
A flexible coating.
Formulated around plastic and rubber surfaces.
Everyday protection.
Helps protect against UV exposure, weathering and wear.
Easier routine care.
Hydrophobic properties help liquids bead on the treated surface.
02 / KNOW YOUR FORMULAThe details
The details
make the difference.
Choose the right product for your surface. Follow the current application and care guidance.
- Product
- PLASTIC
- Category
- Ceramic coating for plastic & rubber
- Size
- 50 ml
- Compatible surfaces
- Interior and exterior plastic and rubber surfaces
Application level2/10
1 = Easiest · 10 = More technique
Easy to apply with basic preparation and the correct product instructions.
Lower scores mean easier application. Higher scores reflect more technique and familiarity with the process. With experience, even a 10/10 product can feel straightforward.
03 / APPLICATION & CAREA considered process.
A considered process.
A lasting impression.
Read the full instructions before you begin.
How To Apply
Pre-Application Preparation: Ensure a clean surface by thoroughly removing any traces of oil, grease, fat, fingerprints, etc., using our recommended PREP solution / APC / Plastic Cleaner.
Tools Required: In addition to the coating material, prepare an applicator pad and a microfiber towel.
Application Method:
Apply an adequate amount of the coating material onto the applicator pad, ensuring it’s sufficiently primed for even distribution. If the applicator feels “stuck”, apply more material as needed.
Commence by outlining the area for application, starting from the surface edges. Then, create a central X shape to facilitate uniform coverage.
Employ crisscross motions to spread the material along the X and Y axes, ensuring thorough coverage.
For optimal results, consider applying an additional layer while the previous one is still “liquid” to guarantee complete coverage.
Buffing Phase: To promote strong adhesion, refrain from wiping the coating immediately post-application. Allow it to soak in before proceeding. Use the microfiber towel to swiftly remove excess material in straight lines; speed is key at this stage, with no need for perfection. Subsequently, flip the towel to buff the surface in circular motions, ensuring no high spots remain.
Curing Times:
Tack-Free: 30 minutes
Initial Curing: 12/24 hours (weather-dependent)
First Wash: 14 days
Full Curing: 30 days
Storage
NANOLAB PLASTIC. has a shelf life of at least 12 months when stored between 0°C / 32°F and 25°C / 77°F in the tightly closed original container.
After opening – must be used within 180 days.
Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable.
In this case however, the properties required for the intended use must be checked for quality assurance reasons.
Maintenance
To effectively maintain your NANOLAB PLASTIC Ceramic Coating, follow these steps:
- Thoroughly clean the surface using APC / Cleaner.
- Reapply the coating as needed for continued protection and performance.
Material Safety Data Sheet
COMPLETE THE PROCESS
All products ↗Find your next step.
YOUR NEXT GREAT FINISH STARTS HERE
Make it PLASTIC.
Connect with a distributor for availability and product support.