BEAST PRO. Professional ceramic coating

BEAST PRO must be applied by a NANOLAB Certified Installer Only!

Pre-Application Preparation: Ensure a pristine surface by thoroughly polishing and removing any traces of oil, grease, fat, fingerprints, etc., using our recommended PREP solution.

Tools Required: In addition to the coating material, prepare an applicator pad and two microfiber towels. Opt for towels of different colors if possible for better organization.

Application Method:
Apply on small areas such as: 1 door, 1/2 hood etc.
Apply in an air-conditioned area with low temperature and low humidity
Do not apply in a direct wind area

1. Apply an adequate amount of the coating material onto the applicator pad, ensuring it’s sufficiently primed for even distribution. If the applicator feels “stuck”, apply more material as needed.
2. Commence by outlining the area for application, starting from the surface edges. Then, create a central X shape to facilitate uniform coverage.
3. Employ crisscross motions to spread the material along the X and Y axes, ensuring thorough coverage.
4. For optimal results, consider applying an additional layer while the previous one is still “liquid” to guarantee complete coverage.

Buffing Phase: To promote strong adhesion, refrain from wiping the coating immediately post-application. Allow it to haze over or display the rainbow effect before proceeding. Use the first towel to swiftly remove excess material in straight lines; speed is key at this stage, with no need for perfection. Subsequently, utilize the second towel to buff the surface in circular motions, ensuring no high spots remain.

Curing Times:
Tack-Free: 1 hours
Initial Curing: 12 hours
First Wash: 14 days
Full Curing: 30 days

NANOLAB BEAST PRO. has a shelf life of at least 12 months when stored between 0°C / 32°F and 25°C / 77°F in the tightly closed original container.
After opening – must be used within 180 days.

Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable.
In this case however, the properties required for the intended use must be checked for quality assurance reasons.

BEAST PRO offers a five-year warranty, ensuring lasting protection for your surfaces.

To maintain the validity of the warranty, it’s crucial to follow these maintenance steps every 6 to 12 months by a NANOLAB Certified Installer:

1. Wash: Begin by thoroughly washing the coated surface using a pH-neutral car shampoo and a microfiber wash mitt. Rinse off any dirt and debris.
2. Decontamination: If necessary, use a clay bar or clay mitt to remove any embedded contaminants from the surface. This step helps maintain the smoothness of the coating.
3. Drying: After washing, dry the surface using a clean microfiber drying towel or a forced-air blower. Avoid air-drying to prevent water spots.
4. Inspection: Carefully inspect the coating for any signs of damage, such as scratches or areas where the coating may have worn off. Address any issues promptly.
5. Maintenance Spray / BEAST365: Apply a ceramic coating maintenance spray or BEAST365 ceramic coating to enhance the hydrophobic properties of the coating and boost its longevity. Follow product’s instructions for application.
6. Inspection and Evaluation (After 5 Years): Given that the coating is now five years old, assess its overall condition and effectiveness. If the coating is significantly deteriorated or damaged, it may be time for reapplication.
7. Reapplication (If Necessary): If the coating is still in good condition but showing signs of wear, consider scheduling a professional reapplication of the ceramic coating to maintain optimal protection.

Throughout the five-year period, it’s essential to avoid using abrasive cleaners or harsh chemicals that could degrade the ceramic coating. Regular maintenance and timely repairs will help maximize the durability and performance of the coating over time.

Download NANOLAB BEAST PRO. MSDS