NANOLAB BEAST Ceramic Coating: Product and Care Guide
Understand BEAST's role as a single-layer clear-coat coating, the preparation it needs and the difference between initial cure and first washing.
Updated · NANOLAB Knowledge
Where BEAST fits
NANOLAB BEAST is presented as a single-layer quartz coating for clear coat, with a focus on slickness and a glossy finish. Choose it for a compatible surface and an installation process that follows the current product instructions. Do not extend its clear-coat description to upholstery, tyre tread or every exterior material without checking.
A coating enhances a prepared finish; it does not remove scratches or repair chips. Inspect, clean and address the agreed correction before the final preparation stage.
Organise the application
The BEAST instructions call for an applicator and two microfiber towels. The described method establishes coverage before removing excess and completing the finish check. Use the product’s stated application cues rather than a timing rule borrowed from a different coating.
Keep the preparation and levelling tools clean. If a towel starts smearing, change its face or replace it and inspect the surface. A test area helps confirm the process under the actual conditions.
Understand the care stages
The product page lists a tack-free stage at one hour, weather-dependent initial curing at 12–24 hours, first washing at 14 days and full cure at 30 days. These are separate milestones. Use the current instructions supplied for the installation, and do not treat tack-free as permission for an ordinary wash.
After the permitted interval, maintain with compatible gentle washing and drying. Investigate contamination before adding another product. For the current product details, read NANOLAB BEAST, and keep the installation record available for future care.
