A full polishing range.
From cutting and one-step correction to final finishing.
Battery-Powered Paint Inspection Lights: Keep the Viewing Setup Consistent
An inspection record should identify the light mode and position as well as the visible defect. Check the lamp’s operating guidance before comparing polishing results.
Updated · NANOLAB Knowledge
Record the selected mode
Identify the lamp and its brightness or colour settings where adjustable. Note the viewing distance and angle. A familiar light housing does not prove that two inspections used the same operating mode.
Review the power condition
Use the lamp manufacturer’s information for operation and any output indications. Confirm that the intended mode remains available during the inspection. Do not assume every battery-powered lamp changes output in the same way as its charge changes.
Use a stable reference
Inspect a defined area with the agreed setup before comparing correction stages. If the light mode or position changes, revisit the reference rather than treating the changed view as new paint evidence.
Keep the acceptance conditions
Record the final inspection method with the polishing result. Photographs should show the relevant condition without replacing the actual review. State any visibility limitations instead of claiming that one lamp configuration exposes every possible defect.
Frequently asked question
Does a lamp’s battery percentage alone describe the inspection light?
No. The actual lamp, mode and manufacturer guidance matter. Keep the working setup and observations in the record.