A full polishing range.
From cutting and one-step correction to final finishing.
Dust Returning During Polish Inspection: Separate New Contamination from Defects
A finish can collect dust while the job is being inspected. Distinguish new surface contamination from remaining paint marks before adding another abrasive stage.
Updated · NANOLAB Knowledge
Use a clean inspection reference
Record the panel condition after the approved residue-removal step. Keep the light and viewing angle consistent. Inspect a defined area rather than judging a whole panel from one reflection where loose particles may be present.
Review the working environment
Identify adjacent cutting, sanding, airflow and other activities that can introduce contamination. Schedule the inspection when the area can be assessed properly. A clean-looking workshop at the start does not establish the panel condition at the final check.
Remove contamination by an appropriate method
Use the finish and product care guidance for the actual material on the surface. Do not rub a dusty panel to discover whether a line is a scratch. Reinspect the dry area after the controlled cleaning step.
Reassess only the remaining marks
If a defect persists, compare it with the original reference and choose the supported next step. Keep recontamination and correction history separately recorded. This prevents extra polishing being used to solve a problem that arose after the accepted finish was achieved.
Frequently asked question
Should more finishing polish be the first response to a speckled reflection?
No. Confirm that the surface is suitable for inspection and identify loose contamination before deciding that more abrasion is needed.