A full polishing range.
From cutting and one-step correction to final finishing.
Review a Metal Coating Mock-Up Under Different Lighting
Make appearance acceptance reflect the actual installation's viewing conditions.
Updated · NANOLAB Knowledge
Decorative metal can look different as lighting and viewing positions change. A coating mock-up should therefore be reviewed in conditions relevant to the final installation. A sample approved under one convenient light may not answer the architect's actual appearance question.
Define the viewing context
Identify the finish, orientation and intended location. Record representative viewing positions and the lighting that matters to the project. Avoid changing the comparison conditions without noting the change. Where the sample cannot be installed in place, explain the limits of the substitute review.
Compare like with like
Keep sample identity, preparation and product instructions documented. Use an appropriate reference area or agreed baseline. For example, a change in reflection caused by moving the sample should not be interpreted automatically as a treatment difference. Review the complete panel where practical rather than only a favourable close-up.
Capture the approval accurately
Record who reviewed the mock-up, the conditions and any reservations. State which finish and product the decision covers. If lighting or panel specification changes later, reconsider whether the approval remains representative. This process does not require an unsupported numerical appearance claim. It requires a shared, reproducible basis for deciding whether the treatment's visible result is acceptable in the setting where the client will actually see it.
Review the mock-up in its intended viewing conditions
Assess the sample under the lighting and orientation relevant to the installed panel, including normal viewing positions. Record any additional inspection light used. Compare with the accepted untreated or prepared reference where appropriate.
Photographs should support the review, but exposure and angle can affect the apparent result. Keep the physical reference available when practical. If reviewers disagree, identify the exact observation and viewing condition rather than averaging their impressions. Document the accepted appearance and any limitation. This makes the mock-up useful during installation and prevents a finish approved under flattering workshop lighting from being assumed acceptable in a differently lit lobby.
Request an application-specific discussion with NANOLAB. For supporting information, review the current product documentation and the stainless-steel guides.